Cord Drawn Curtain Tracks Instructions

Replace sliders at each end.

Cord drawn curtain tracks instructions.

To drill holes identify where the holes should be positioned and mark the track. Most curtain tracks do not have the mounting holes pre drilled. I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks. Remove the curtain rod from the.

Remove the curtains from the traverse rods so you can access the cording. Click here for how to mend it. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. 3 unhook cord from master carrier and allow to drop inside track.

First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. Place pulley 2 onto track section and secure with screws. Measure the rod s length while it is still on the wall. Curtain track features and how to install.

Standard drill bits work fine on all aluminum tracks. Re attach track onto brackets and re hang curtains. If you re removing an old cord you can untie it. Using a small bit drill pilot holes centered in the slot through the top of the track.

Add those two. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. Holding the cords taut push carrier 2 as far to the left as possible. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud.

Hook cord over the lug on carrier 2 to secure it. Cord on overlap master carrier as original. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. How to fit new cord to curtain tracks take measurements.

2 pull track apart at the centre. Draw the cord until the right hand carrier 1 is as far to the right as possible. Next place the rod face down on a flat surface. Then remove master carrier from the track.

Then feed cord around and over the top pulley g pass cord back through ovelrap master slide. Installing your styletrack curtain track. Once you have worked out were your track is going to go.